SIZE: 4 Liter ( 4000ML )
Composition/type: methacrylate monomers
Appearance/Color: translucent, amber liquid
Viscosity @25ºC : 5-10 cP
Specific Gravity: 1.03
Flash Point: >200ºF
Vapor Pressure: Less than 5 mm Hg at 72° F
Water solubility: soluble in water
Cure Application: Heat cure sealing
Appearance: hard, translucent, acrylic
Hardness Shore D (ASTM D2240): 75-85
MU Juice is heat cured at temperatures between 80ºC -96ºC, (177º F -205º F ). MU Juice cures when the temperature of the resin within the blank reaches 90º C for a minimum of three minutes.The typical small shop method for curing is in a counter top toaster oven until internal blank temperature reaches the cure temperature for five minutes or more. This usually take 1-1.5 hours for a typical small batch of 10 pen blanks. Blanks with large cross section areas or larger batches of blanks may require longer processing times to achieve the required cure temperature.
SERVICE TEMPERATURE RANGE
MU Juice is formulated from the highest quality monomers to maximize the service operating range of the polymer. Is recommended for continuous service from –54ºC, (-65ºF) to 189ºC, (372ºF).
Storage temperatures should be maintained below 28ºC (82ºF). Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. Storage in a refrigerator is recommended.
Rubber gloves should be worn when handling liquid MU Juice. Avoid prolonged contact with skin and wash thoroughly with water and mild soap if contact occurs. If dermatitis occurs, seek medical attention and avoid further exposure. Avoid accidental contact with the eyes by using safety glasses. If accidental contact with the eyes should occur, flush immediately with copious amounts of clean water and obtain medical attention.
Cured MU Juice is inert and can be disposed of as ordinary industrial trash. Uncured resin should be cured before disposal. Resin in solution in wash water effluent is biodegradable.
BELOW IS THE WOOD STABILIZE PROCESS
You will need have vacuum chamber, air compressor and microwave or oven
Before stabilize the weight is 5.7 Gram
After stabilized the weight become 19.2 gram
Start vacuum you will see alot of bubble, keep the vacuum going until you see very few bubbles coming from the blanks. after all the air has been evacuated, release the vacuum and turn of your pump. allow the excess mu juice to drain from the blanks and then wrap them in aluminum foil.
The blanks just take out from the oven.
We try to drill a hole to ensure the inner part is solid, fully absorb Mu juice and dyes
after stabilized, the wood become solid, it will be sink on the water
HERE IS THE WOOD AFTER STABILIZED USING MU JUICE BY ADDING DYES
is really work for stabilize my soft burl wood. would buy again. 5star